Description
The FAHRER Motor Cover is a quality product that is designed to protect the motor of an e-bike during transport on the roof or on a luggage rack mounted on the towbar or rear door. If you want to take your e-bike on vacation, it is often transported in or on a vehicle. Fixed to the roof or the luggage rack, the bike is exposed to rain and splash water while driving, which can penetrate the motor due to the high impact pressure. The MOTOR COVER PREMIUM, made of high-quality elastic neoprene, protects the motor of your e-bike during transport against weather influences such as rain and stones. This guarantees the long-term performance of the motor. The elastic material of the COVERS allows for precise adjustment to mid-engine models from different manufacturers: Note: The Motor Cover is a transport protection and must be removed before you start riding. The Motor Cover is not intended to keep the engine housing dry. The holes in the bottom of the cover channel rainwater away. If cleaning is necessary, we recommend washing it by hand with a mild soap. Features: Suitable for any e-bike with a mid-engine such as BOSCH, SHIMANO, IMPULSE, YAMAHA, BROSE, TranzX and PANASONIC can be adjusted to individual frame and engine geometry. When properly assembled, it fits snugly around your engine and frame and does not cause any scratches like loose bags in the airflow during riding. The Motor Cover is a transport protection (must be removed before riding) and is not designed to keep the engine housing dry. Material: High-quality neoprene. Easy to install. Variable pedal position possible, left or right forward and approx. 45 degrees up or down to adjust to the rear carrier. Fits all e-bikes with a mid-engine such as BOSCH, SHIMANO, IMPULSE, YAMAHA, BROSE, TranzX and PANASONIC. Designed in Berlin and produced in the EU. Assembly: Place the MOTORCOVER on the engine from the chain/chainring side with the Velcro fasteners open. Place the large lip around the bottom of the engine and fold it over to the other side of the engine. Fasten the flap with the Velcro fasteners. Finally, attach the top flap with the driver's logo between the lower tube of the frame and the engine, tighten it tightly and close with the Velcro fastener.
